FujiFilm FinePix F30 or, flash, Flash, battery, blurred, selected, pictures, cannot be, than sand H, The playback, The image is, on the image, image is dark, Cannot use the

Troubleshooting

Matters	Problems	Possible causes		Solutions	Page
		The shutter button was pressed while the		Wait until the charging is completed before	57
		flash was charging.		pressing the shutter button.
		The Shooting mode is set to	, ,, ,	Change the Shooting mode.	42
	Cannot use the	, or .
	flash.	The battery has run out.		Charge the battery or load fully charged	15,
				battery.	17,
					126
Flash		Continuous shooting is selected.		Set continuous shooting to OFF.	72
	The flash settings	The Shooting mode is set to anything other		The flash settings are restricted because
	are restricted and	than sand H.		the camera settings are tailored to the	42
	cannot be			scene being shot. Change the Shooting
	selected.			mode for a wider range of flash settings.
	The playback	The subject is too far away.		Move to within the effective flash range	55, 57
	image is dark			before taking the picture.
	even though the
		Your finger was covering the flash.		Hold the camera correctly.	26
	flash was used.
		The lens is dirty.		Clean the lens.	125
		{appeared when taking pictures.		Check the focus on the subject and take	27,
	The image is			pictures.	30,
	blurred.				131
Photographed images
		appeared when taking pictures.		It may cause camera shake. Hold the	28,
				camera steadily.	131
	There is speckling	The picture was taken with a slow shutter		This is a characteristic of CCDs and does
		speed (long exposure) in a high-		not indicate a camera fault.	–
	on the image.	temperature environment.

138