14 15
Getting Ready
2
●
!
Insert only the appropriate media types into the xD-Picture Cardand Microdrive slots. Inserting the incorrect media
will damage the camera or media.
●
!
If the media is oriented incorrectly, it will not go all the way into the slot. Do not apply excessive force when inserting
an xD-Picture Cardor Microdrive.
●
!
If the media is not fully inserted into the slot, the “å” message appears.
Gold marking
Align the gold marking on the xD-Picture
Card slot with the gold contact area on
the xD-Picture Card and push the card
firmly all the way into the slot.
Push the Microdrive firmly all the way into
the Microdrive slot.
xD-Picture Card Microdrive
3Close the slot cover.
Use either xD-Picture Card or Microdrive as recording media in the FinePix S20 Pro.
hIf an xD-Picture Card and a Microdrive are inserted at the same time, images will be recorded
onto the media selected as the “MEDIA” (➡P.83).
hData cannot be copied between the two media types on the FinePix S20 Pro.
1Set the Power switch to “OFF”, check that the
indicator lamp is off and then open the slot cover.
●
!
If opening the slot cover while the camera is still on, the
camera will turn off.
INSERTING THE MEDIA
Do not open the slot cover while the camera is still
turned on. This could damage the media or corrupt
the image files on the media.
◆How to replace
the xD-Picture Card ◆Push the xD-Picture Card into the slot and
then slowly remove your finger. The lock is
released and the xD-Picture Card is pushed
out.
◆How to replace
the Microdrive ◆Open the slot cover, press the Microdrive eject
button and remove the Microdrive.
●
!
When storing Microdrives, always use the special
protective case.
Microdrive eject button
●
!
The information above is a guide for photography mode. Depending on the camera mode and the type of batteries
used, the transition from “C” to “V” may occur more quickly.
●
!
When the batteries run out, “V” appears and camera operation stops. When this occurs, the camera may work if
you turn it on again even without loading new or fully charged batteries. However, this may cause camera faults such
as the camera turning itself off without retracting the lens. Always load new or fully charged batteries.
●
!
Due to the nature of the battery, the battery low warning may appear early when the camera is used in cold
locations. This is normal. Try warming the batteries in your pocket or a similar location before use.
“C” appears as a small icon on the right-hand
side of the screen. “V” appears as a large icon
on the screen.
Turn the camera on and check that no battery level warning (“C” or “V”) appears on the
screen. If no icon appears, there is ample charge left in the batteries.
1There is ample battery charge.
2There is insufficient charge left in the batteries.
The batteries will soon run out. Have a new set
of batteries ready.
3The batteries are depleted. The display will
shortly go blank and the camera will stop
working. Replace or recharge the batteries.
Blinking red
Lit red
1
2
3
No icon
Blinking red
Lit red
◆Power save function ◆
When this function is active, it also turns off the screen (Sleep mode) to reduce power consumption if
the camera is not used for 30 seconds (➡P.86). If the camera is then left unused for 2 minutes or 5
minutes, the Power save function turns the camera off. To turn the camera back on, set the Power
switch to “OFF” briefly and then back to “q” or “w”.