|
|
|
|
|
|
|
|
|
| For Your Safety | |
|
|
|
|
|
|
|
|
|
| ||
Power Lines: An outside antenna sys- |
|
|
|
| Replacement Parts: When replace- | ||||||
Use | Service | ||||||||||
tem should not be located in the | Cleaning: Unplug this video product |
| Servicing: Do not attempt to service |
| ment parts are required, be sure | ||||||
vicinity of overhead power lines or | from the wall outlet before clean- | this video product yourself as open- | the service technician has used | ||||||||
other electric light or power circuits, | ing. Do not use liquid cleaners or | ing or removing covers may expose | replacement parts specified by the | ||||||||
or where it can fall into such power | aerosol cleaners. Use a damp cloth | you to dangerous voltage or other | manufacturer or have the same | ||||||||
lines or circuits. When installing an | for cleaning. | hazards. Refer all servicing to quali- | characteristics as the original part. | ||||||||
outside antenna system, extreme | Object and Liquid Entry: Never push | fied service personnel. | Unauthorized substitutions may | ||||||||
care should be taken to keep from | result in fire, electric shock or other | ||||||||||
touching such power lines or circuits | objects of any kind into this video | Damage Requiring Service: Unplug this | hazards. | ||||||||
as contact with them might be fatal. | product through openings as they | video product from the wall outlet | Safety Check: Upon completion of any | ||||||||
|
|
|
|
|
| may touch dangerous voltage | and refer servicing to qualified ser- | ||||
EXAMPLE OF ANTENNA GROUNDING | points or short out parts that could | vice personnel under the following | service or repairs to this video prod- | ||||||||
AS PER NATIONAL ELECTRICAL CODE | result in a fire or electric shock. Never | conditions: | uct, ask the service technician to | ||||||||
Ground Clamp | Antenna | spill liquid of any kind on the video | When the | perform safety checks to determine | |||||||
product. | plug is damaged. | that the video product is in proper | |||||||||
|
|
|
|
| Lead in Wire | ||||||
|
|
|
|
|
|
| If liquid has been spilled, or objects | operating condition. | |||
|
|
|
|
|
| Lightning: For added protection for | |||||
| Electric |
|
|
| have fallen into the video product. |
| |||||
|
|
| this video product receiver during |
| |||||||
| Service |
|
| ||||||||
|
| a lightning storm, or when it is left | If the video product has been ex- |
| |||||||
Equipment |
|
| |||||||||
Antenna | unattended and unused for long pe- | posed to rain or water. |
| ||||||||
|
|
|
|
|
| ||||||
|
| Discharge Unit | riods of time, unplug it from the wall | If the video product has been |
| ||||||
Ground |
| ||||||||||
|
|
| (NEC SECTION | outlet and disconnect the antenna | dropped or the cabinet has been |
| |||||
Clamps |
|
| |||||||||
|
|
|
|
| or cable system. This will prevent | damaged. |
| ||||
| Power Service | If the video product does not op- |
| ||||||||
Grounding Electrode | Grounding | damage to the video product due to | erate normally be following the |
| |||||||
System (NEC ART 250. | Conductors | lightning and | operating instructions. Adjust only |
| |||||||
|
|
| PART H) | (NEC SECTION |
|
| those controls that are covered by |
| |||
the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the video product to its normal operation.
When the video product exhibits a distinct change in performance - this indicates a need for service.
iii