PREPARATION
Turn on the Power
1 | Turn on the circuit breaker |
| |||||
Load Batteries (AAA/R03/LR03 ⋅ 2) |
| ||||||
1 | Press and slide the battery compartment lid on the | ||||||
reverse side to open it. |
|
|
|
| |||
| Slide in the direction of the arrow while pressing the mark. | ||||||
2 | Insert batteries. |
|
|
|
| ||
Be sure to align the battery polarities ( | ) correctly. | ||||||
3 | Close the battery compartment lid. | ||||||
Set the Current time |
|
|
|
| |||
1 | Press the CLOCK ADJUST button (Fig. 5 P). | ||||||
Use the tip of a | |||||||
2 | Use the TIMER SET ( | / |
|
| ) buttons (Fig. 5 O) to | ||
|
| ||||||
adjust the clock to the current time. | |||||||
|
|
| button: Press to advance the time. |
| |||
|
|
| button: Press to reverse the time. |
| |||
|
|
|
| ||||
| (Each time the buttons are pressed, the time will be advanced/reversed | ||||||
| in | ||||||
| time quickly in |
| |||||
3 | Press the CLOCK ADJUST button (Fig. 5 P) again. | ||||||
This completes the time setting and starts the clock. | |||||||
CAUTION!
●Take care to prevent infants from acci- dentally swallowing batteries.
●When not using the Remote Control- ler for an extended period, remove the batteries to avoid possible leakage and damage to the unit.
●If leaking battery fluid comes in contact with your skin, eyes, or mouth, imme- diately wash with copious amounts of water, and consult your physician.
●Dead batteries should be removed imme- diately and disposed of properly, either in a battery collection receptacle or to the appropriate authority.
●Do not attempt to recharge dry batteries.
Never mix new and used batteries, or batteries of different types.
Batteries should last about one year under normal use. If the Remote Con- troller's operating range becomes appreciably reduced, replace the bat- teries and press the RESET button with the tip of a ballpoint pen or other small object.
To Use the Remote Controller
●The Remote Controller must be pointed at signal receiver (Fig. 3 4) to operate correctly.
●Operating Range: About 23ft (7 m).
●When a signal is properly received by the indoor unit, a beeping sound will be heard.
●If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
Insert | Slide up |
Press in | Pull out |
| |
Screws |
|
1 Mount the Holder. 2 Set the Remote Controller. | 3 To remove the Remote Con- |
| troller (when use at hand). |
