NAME OF PARTS
Fig. 1 Indoor Unit
1Operating Control Panel (Fig. 2)
2MANUAL AUTO button
●When kept on pressing the MANUAL AUTO button for more than 10 seconds, the forced cooling operation will start.
●The forced cooling operation is used at the time of installation.
Only for authorized service personnel’s use.
●When the forced cooling operation starts by any chance, press the START/STOP button to stop the operation.
3Indicator (Fig. 3)
4Remote Control Signal Receiver
5OPERATION Indicator Lamp (red)
6TIMER Indicator Lamp (green)
●If the TIMER indicator lamp flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (See Page 17 Auto Restart).
7AIR CLEAN Indicator Lamp (green)
8COIL DRY Indicator Lamp (orange)
9Intake Grille (Fig. 4)
0Air Filter
AAir Flow Direction Louver
B
(behind Air Flow Direction Louver)
CDrain Hose
DElectrical Air Cleaning Filter
EPower Supply Cord
FPower Supply Plug
Fig. 5 Outdoor Unit
GIntake Port
HOutlet Port
IPipe Unit
JDrain port (bottom)
●Refer to the folded out page on the cover.
Fig. 6 Remote Control Unit
KSignal Transmitter
LMASTER CONTROL button
MFAN CONTROL button
NSTART/STOP button
OAIR CLEAN button
PCOIL DRY button
QSET button
RSET TEMP. button ( / )
SSLEEP button
TSWING button
UTIMER MODE button
VTIMER SET ( / )buttons
WTEST RUN button
●This button is used when installing the conditioner, and should not be used un- der normal conditions, as it will cause the air conditioner’s thermostat function to op- erate incorrectly.
●If this button is pressed during normal op- eration, the unit will switch to test opera- tion mode, and the Indoor Unit’s OPERA- TION Indicator Lamp and TIMER Indicator Lamp will begin to flash simultaneously.
●To stop the test operation mode, press the START/STOP button to stop the air condi- tioner.
XCLOCK ADJUST button
YRESET button
ZRemote Control Unit Display (Fig. 7) [ Temperature SET Display
\ Transmit Display
] Operating Mode Display ` Fan Speed Display
a AIR CLEAN Display b SWING Display c COIL DRY Display d Timer Mode Display e SLEEP Display
f Clock Display