AIR CLEANING OPERATION
If you wish to eliminate dirt,dust,cigarette smoke, pollen, or just simply purify the air of the room, use the Air Cleaning Mode.
1
2
Press the START/STOP button (Fig. 6 N).
The OPERATION Indicator Lamp (red) (Fig. 3 5) will light. (If the unit is already in operation, please proceed to step 2.)
Press the AIR CLEAN button (Fig. 6 O).
The AIR CLEAN Indicator Lamp (green) (Fig. 3 7) will light up.
●Air conditioning and Air Cleaning will function simultaneously.
If you wish to stop Air Clean
Press the AIR CLEAN button (Fig. 6 O) once again.
The AIR CLEAN Indicator Lamp (green) (Fig. 3 7) will go out.
●This will only stop the Air Cleaning, the air conditioner will continue operating.
To also stop the air conditioner
Press the START/STOP button (Fig. 6 N).
The OPERATION Indicator Lamp (red) (Fig. 3 5) will go out.
●The next time the START / STOP button (Fig. 6 N) is pressed air conditioning and air cleaning will both resume operating.
Air cleaning
●During operation, the unit produces a small amount of ozone that can be smelled.
●When this unit is used in combination with the ultrasonic humidifier, white parti- cles may become attached to the plasma filter unit. If this happens, clean the plasma filter unit as soon as possible. (Refer to page 13, 14.)
●The air cleaning operation cannot remove gases such as carbon monoxide and alcohol from the air. During operation, ventilate the room often to prevent as- phyxiation or suffocation.
●If the intake filter is removed during operation, a safety device will stop the op- eration of the plasma filter unit. If this happens, the AIR CLEAN Indicator Lamp (green) on the indoor unit will flash after some time has passed. Use the START/ STOP button on the remote controller to stop the operation, install the intake filter, and then use the START/STOP button to restart the operation.
●Use the FAN CONTROL button to change the fan speed. (Refer to page 5.) The plasma filter unit operates most effectively at the highest fan speed.
●The AIR CLEAN Indicator Lamp (green) will flash to inform you that the periodic cleaning of the plasma filter unit is required. (Refer to page 13, 14.)
