Fujitsu C-6651 Primary Master Submenu of the Main Menu, Auto, Enter, Menu Field, Options, Default

L i f e B o o k C S e r i e s B I O S

Primary Master Submenu of the Main Menu

The Primary Master submenu identifies what ATA devices are installed.

*Note that actual hard drive label shown may vary. Depending on the drive type, information such as cylin- ders, heads and sectors may also be displayed.

PhoenixBIOS Setup Utility

Main

Primary Master [TOSHIBA MK3018GAP -(PM)]		Item Specific Help
Type:	[Auto]	Select ATA/ATAPI drive
Maximum Capacity:	30006MB	installed here.
Multi-Sector Transfers:	[16 Sectors]	[Auto]
LBA Mode Control:	[Enabled]	The BIOS auto-types the
PIO Transfer Mode:	[Fast PIO 4]	drive on boot time.
DMA Transfer Mode:	[Ultra DMA 5]
		Except [Auto]
		You enter parameters of
		the drive.
		[None]
		The drive is disabled.

F1	Help	Select	Item
ESC	Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 2. Primary Master Submenu

Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu

Menu Field	Options		Default	Description
Type:	n	Auto	[Auto]	Selects the ATA/ATAPI device type. Select Auto to have the type
	n	None		automatically identified by the BIOS at POST. If None is selected, all of the
	n	CD-ROM		following Set-up items do not appear. Select CD-ROM if a CD-ROM drive
	n	Hard Disk		is installed at this connection. If Hard Disk is selected, you must specify the
				number of Cylinders, Heads, and Sectors for the drive.
Cylinders:	n	A number	–—	This appears only when Hard Disk is selected. When Hard Disk is selected,
		between		you can change the value. This field is incremented by pressing the
		0 and 65,535		[Spacebar]) or by pressing [Shift] [+]. This field is decremented by pressing
				the [-] key. You can also change the field by typing in the number.
Heads:	n	A number	–—	This appears only when Hard Disk is selected. When Hard Disk is selected,
		between		you can change the value. This field is incremented by pressing the
		1 and 16		[Spacebar]) or by pressing [Shift] [+]. This field is decremented by pressing
				the [-] key. The field can also be changed by typing in the number.
Sectors:	n	A number	–—	This appears only when Hard Disk is selected. When Hard Disk is selected,
		between		you can change the value. This field is incremented by pressing the
		0 and 63		[Spacebar]) or by pressing [Shift] [+]. This field is decremented by pressing
				the [-] key. The field can also be changed by typing in the number.

6