How to operate the tuner
ATTENTION
If stations have been stored in memory, pressing a button from [1] to [6] will directly select a station. (Refer to "Manually setting stations into memory" on page 18.)
CAUTION
If the vehicle’s battery is disconnected (for repairs to the vehicle or for removing the receiver), all stations in memory will be lost. In such a case, set stations in the memory again.
Tuning to a stationPress the [BAND] button to switch1 to the desired FM, AM bands.Radio bands will switch from FM1 ➔ FM2 ➔ FM3 ➔ AM in order each time the button is pressed.
2 Press the [
] or [
] button to start the automatic station search.[ 
] button:
Starts searching toward higher frequencies.
[ 
] button:
Starts searching toward lower frequencies.
● MEMO ●
To tune to a station manually;
ATTENTION
At times, it may be difficult to maintain optimum reception because the antenna affixed to your vehicle is in motion constantly (relative to the broadcast antenna), encountering continuous variation in the received radio signals’ strength. Other factors affecting reception include interference from natural obstacles, sign posts, etc.
Entering stations into memory automatically(The automatic preset mode: ASM)ASM is available for the FM radio mode.
1 Press the [BAND] button.You can switch the mode to desired one.
2 Press the [FUNC] button.Press the [3] button for several3 seconds while [FUNC] is blinking.The automatic preset mode starts.
[ASM ON] will appear on the display, and stations are automatically entered in memory under the buttons [1] to [6].
These buttons are called preset buttons.
IV
V
Press the [ 
] or [ 
] button until “M” is displayed. When “M” is displayed, press the [ 
] or [ 
] button to select a station you want to listen to.
17