Fujitsu D1411 technical manual SCSI-Bus Interface Definitions Standardeinstellung

SCSI/Host RAID-Konfigurationsprogramm Leistungsmerkmale

Standardeinstellungen im Menü Configure/View SCSI Controller Settings

SCSI-Bus Interface Definitions	Standardeinstellung
SCSI-Controller ID	7
SCSI-Controller Parity	Enabled
SCSI-Controller Termination	Enabled
Additional Options	Standardeinstellung
Boot Device Configuration	Press <Enter>
Single Image
Master SCSI-Controller	AIC-7902 at slot 00 00:04:00
Select SCSI peripheral from which to boot
Boot SCSI-Controller	AIC-7902 at slot 00 00:04:00
Boot SCSI ID	0
Boot LUN Number*	0
SCSI Device Configuration	Press <Enter>
Sync Transfer Rate (MB/Sec)	320
Packetized	Yes
QAS	Yes
Initiate Wide Negotiation	Yes (Enabled)
Enable Disconnection	Yes (Enabled)
Send Start Unit Command****	Yes
BIOS Multiple LUN Support	No
Include in BIOS Scan	Yes
Advanced Configuration	Press <Enter>
Reset SCSI Bus at IC Initialization	Enabled
Display <Ctrl><A> Message During BIOS Initialization	Enabled
Extended Int 13 Translation for DOS Drives >1GByte	Enabled
POST Display Mode	Verbose
SCSI-Controller Int 13 Support	Enabled
Domain Validation****	Enabled
Support Removable Disks under Int 13 as Fixed Disks****	Disabled
BIOS Support for Bootable CD-ROM****	Enabled

*Die Einstellung ist nur dann wirksam, wenn Multiple LUN Support eingeschaltet (Enabled) ist.

****Die Einstellung ist nur dann wirksam, wenn der Int 13 Support des SCSI-Controllers eingeschaltet (Enabled) ist.

A26361-D1411-Z120-3-7419 Deutsch - 15