Fujitsu E8110 manual for more information, Shutdown and Startup Problems

E8110.book Page 56 Tuesday, February 28, 2006 2:59 PM

L i f e B o o k E 8 0 0 0 N o t e b o o k

	Problem	Possible Cause		Possible Solutions
	Your LifeBook notebook	You are operating on battery	Install a power adapter and then push the Power/
	turns off all by itself.	power and ignored a low batt-	Suspend/Resume button. (See Power Sources on
	(continued)	ery alarm until the batteries are	page 27 for more information)
		at the dead battery state and
		the system has gone into Dead
		Battery Suspend mode.
		You have a battery failure.	Verify the condition of the batteries using the
			Status Indicator panel, and replace or remove
			any batteries that are shorted. (See Status Indicator
			Panel on page 12 for more information)
		Your power adapter has failed	Make sure the adapter is plugged in and the outlet
		or lost its power source.	has power.
	Your LifeBook notebook	The installed batteries	Replace the battery with a charged one or install
	will not work on battery	are dead.	a power adapter.
	alone.
		No batteries are installed.	Install a charged battery.
		The batteries are improperly	Verify that the batteries are properly connected
		installed.	by re-installing them.
		Your installed batteries	Verify the condition of the batteries using the Status
		are faulty.	Indicator panel and replace or remove any batteries
			that are shorted. (See Status Indicator Panel on
			page 12 for more information)
	The batteries seem to	You are running an application	Use both the primary battery and an optional
	discharge too quickly.	that uses a lot of power due to	second battery and/or use a power adapter for this
		frequent hard drive access or	application when at all possible.
		optical drive access, or use of a
		modem, LAN PC card, Wire-
		less LAN, or Bluetooth device.
		The power savings features	Check the Power Options menu settings and adjust
		may be disabled.	according to your operating needs.
		The brightness is turned all	Turn down the brightness adjustment. The higher
		the way up.	the brightness the more power your display uses.
		The batteries are very old.	Replace the batteries.
		The batteries have been	Replace the batteries.
		exposed to high temperatures.
		The batteries are too hot	Restore the notebook to normal operating tempera-
		or too cold.	ture. Charging icon on the Status Indicator panel
			will flash when battery is outside of operating range.
	Shutdown and Startup Problems
	The Suspend/Resume	Suspend/Resume button is	Enable the button by going to the Control Panel ->
	button does not work.	disabled.	Power Options Properties and clicking on the
			Advanced tab. In the Power buttons area, select the
			option that best suits your needs.
		There may be a conflict with	Close all applications and try the button again.
		the application software.
56