This Acrobat version does not support Windows® 2000 and Windows Server® 2008.

Installing the Scanner

Place the scanner at its installation site.

394

2. Connect the scanner to your computer either with a USB or SCSI cable.zYou cannot make both USB and SCSI cable connections at the same time.zYou cannot connect multiple computers to the scanner at the same time.

zTo scan using TWAIN/ISIS, connect the cable to USB Connector 1 or

310

3(1550 .51)

SCSI Connector 1 on the scanner.

 

 

(12.20)

 

 

430

 

 

 

 

 

 

 

 

(16430 .93)

 

 

460

1630

 

 

(18.11)

(64.17)

860

460

 

 

 

(33.86)

 

 

 

Unit: mm (in.)Scanner’s DimensionsInstallation SpacezThe scanner weight is 32 kg (70.56 lb). You must not carry it alone.zCarry the scanner by supporting it from the bottom.

Connecting the Cables

The following describes how to connect the cables between the scanner and your computer.

USB Connector 2SCSI Connector 1
SCSI Connector 2 USB Connector 1
CGA Board (when Kofax VRS is used)

2

SCSI ID

3

Power CableSCSI Cable

1

USB Cable1. Make sure that the computer is turned OFF.

To scan using Kofax VRS, connect the cable to USB Connector 2 or SCSI Connector 2 on the scanner.

zTurn off the scanner and your computer whenever you switch the interface cable.

The following describes the requirements for connecting with the respective cables.

zUSB cable

-Be sure to use the USB cable which comes as an accessory with this scanner.

-When connecting to an USB hub, use the first stage USB hub that is closest to the computer. If you use the second or later hub stages, the scanner may not operate cor- rectly.

-If you connect the scanner with USB 2.0, it is required that the USB port and the hub be compliant with USB 2.0. The scanning speed slows down when you connect the scanner with USB 1.1.

zSCSI cable

Be careful not to damage any pins of the SCSI connector when connecting the scanner to your computer.

-When using the scanner with a SCSI inter- face, the following types of SCSI cable and SCSI card must be purchased.

SCSI cable:

Use a SCSI cable whose connector on the computer side mates to the connector on the SCSI card installed on your computer. On the scanner side, use either of the following SCSI cable types depending on the connector (1 or 2) used:

SCSI Connector 1: 50-pin high-density typeSCSI Connector 2: 68-pin high-density typeSCSI card:

Find the recommended SCSI card information on the Fujitsu website (FAQ): http://www.fujitsu.com/global/support/com- puting/peripheral/scanners/scsi/

-In a SCSI daisy chain formation, connect the scanner so that it is the terminated device.

5