-The SCSI ID initially set at the factory is [5]. If the SCSI ID of another SCSI device is set to the same ID, change the scanner's SCSI ID to [0] through [6].

3. Connect the power cable to the power connector of your scanner and to the power outlet.

WARNING

Be sure to use the supplied power cable. The following cases may cause electrical shock or malfunction.

zUsing a power cable other than that suppliedzUsing the supplied power cable for other devices

Test-Scanning Documents

Using ScandAll PRO, you can test-scan documents to check if they are scanned correctly. The following describes how to test-scan a document:

1. Turn on the scanner.1.Press the "I" side of the main power switch on the rear side of the scanner.

2.Press the power button on the front of the scanner. The scanner is turned ON, the power button lights in blue, and the liquid crystal display (LCD) shows [Ready].

If you see an error indication other than the above on the LCD, refer to "Chapter 8 Troubleshooting" in the Operator's Guide.

LCDOverlayPower Button

2. Replace the current operator panel overlay with the one for the language to be used, and specify the language to be shown on the LCD.

For how to replace the overlay and specify the language setting, refer to "Chapter 4 How to Use the Operator Panel" in the Operator’s Guide.

3. Turn on your computer.

For a SCSI connection, turn on the scanner and confirm that the LCD shows [Ready]. Then, turn on your computer.

4. The scanner is automatically detected, and the [Found New Hardware] dialog box appears. Select [Locate and install driver software (recommended)] to install the driver, following the on-screen instructions.

If the connection is made via SCSI Connector 2, there is no need to install the driver here. Just click [Don't show this message again for this device].

5. Load a sheet into the scanner.For loading a sheet, refer to "2.1 Loading Documents" in the Operator's Guide.6. Launch ScandAll PRO.

Select the [Start] menu J [All Programs] J [Fujitsu ScandAll PRO] J [ScandAll PRO].

7. Select the [Tool] menu J [Preferences].D The [Setup] dialog box appears.8.On the [Scan] tab, select a driver to use, and then click the [OK] button.When the connection is made via SCSI/USB Connector 2, click [ISIS/VRS].

6