(2) Select Vertical Pitch command
The Select Vertical Pitch command specifies the printer line feed pitch (6
or 8 lpi).
When 6 lpi is specified, the parameter is 31 32 30, as follows:
1B
5B
or
i
31 32
ab
20 47
9B
t
L---Parameter
When 8 lpi is specified, the parameter is 39 30, as follows:
IB
5B
or 39 30 20 47
9B
17
Parameter
If the parameter has a value other than the value
abcve,
it is regarded as
an invalid control sequence and the specified
operati,on
is not performed.
(3) Set to Initial State command
The Set to Initial State command returns the FCB
(EVFU)
contents to the
set value,
clears the horizontal control buffer
(HCB)
in which the
horizontal tab stop data is loaded, returns the printer line feed pitch to
that specified by the setting, and inhibits the printer from translating
data codes when the printer receives the SO code.
However,
an error caused by the printer, for example, hammer check or band
speed check, is not cleared.
(4) Skip to Channel-n
command
The skip to Channel-n command directs the printer to feed forms up to the
line corresponding to the channel specified in the
FC:B
data after data
received before this command is printed. The channel number is specified
by the parameter as follows:
X'31'
-Channel
1
X'37' Channel
7
X'32'
-Channel 2
X'38'
Channel 8
X'33'
-Channel 3
X'39'
Channel 9
X'34'
-Channel 4
X'31
30'
-
Channel 10
X'35'
-Channel 5
X'31
31'
-
Channel 11
X'36'
-Channel 6
X'31
32'
-
Channel 12
This control sequence is regarded as invalid under
thse
following
conditions:
. The
.channel
specified in this
connnand
is not present in the FCB
(EVFU)
even though the FCB
(EVFU)
is loaded.
. This command is specified even though the FCB is not loaded. If channel
1
is specified, however, the printer prints
receivemd
data and feeds
forms up to the TOF line.
B02P-1500-OOOlA...05 6
-
23