2.3.4 Setting the SCSI ID
This section explains how to set the SCSI ID.
Set the SCSI ID as follows:
1)Disconnect the power cable from the outlet.
2)Set the device address using the SCSI ID switch on the back of the image scanner.
| Notes concerning device address setting |
|
|
Address No. | Meaning |
|
|
0 to 7 | These address numbers can be set. |
|
|
8, 9 | The factory default value (SCSI ID = 5) is used for these numbers. |
|
|
3)After setting the address number corresponding to the target SCSI ID, connect the power cable to the outlet.
M3092DC Image Scanner Operation Guide |