Fujitsu M4099D Operator Panel

1-5

Arrangement

Operator panel

The operator panel is located at the lower right hand side of the scanner. The panel consists of an

LCD (24 character x 2 line), LEDs, and buttons.

Operator Panel

DATA CHECK POWER

ENTER

CANCEL

LCD

24 characters x 2 lines

Contents

Main Page North American contact: European contact: Australian contact: Please send your comments on this manual or on Fujitsu products to the following addresses: Asian contact: IMPORTANT NOTE TO USERS Preface Conventions CONTENTS Page COMPONENTS Checking the Components Units and Assemblies Units Page Assemblies Arrangement Operator Panel 1-6 Button/LED Function POWER DATA CHECK LCD Display Operation status display Error status display Buzzer Page Precautions Page Page Page Page Page Page Basic Operation of the Operator Panel Displaying detailed information if an error occurred Lifting or lowering the hopper Clearing a consumable life alarm Confirming the number of sheets processed by the scanner Using the function buttons (F1, F2, and F3) Using the setup, browse, and test modes 3-8 * Turn off to quit <<MODE SELECT>>. : Cursor buttons : Blinking 3-9 Transition of operator panel status and display The following outlines the transition of status and display of the operator panel. Turn power off to quit. Error occurred Page A Feeding Direction B Document Size Document Quality Paper types of documents Ream weight of paper Precautions Page Page Installation Specifications Page Consumables Page SETUP, BROWSE, AND TEST MODES Setup, Browse, and Test Modes Functions not available in setup mode Functions not available in browse mode Activating the Setup or Browse Mode SETUP BROWSE XXXXX Button functions in setup or browse mode Mode selection ( 6-3 MENU pressed in Ready status) ENTER Contents of the Setup or Browse Mode 6-5 6-6 Setup mode menu screen : Cursor buttons : Blinking * To save the change, press ENTER. To quit without saving change, press CANCEL. Transition of screens in setup mode Settings Page Paper length check ON 10 mm Paper thickness check Paper thickness setup Page Skew check IPC-3 mode IPC-3 Mode Paper types and corresponding pattern numbers 6-16 Hopper height This function sets the initial height of the hopper. Set the height which you frequently use. Reading parameter validity Page Paper separation level Set braking power according to the table below. Page Drop-out color Page Consumable counter Buzzer Page Buzzer volume LCD contrast Picking speed Page Interface TP_IF baud rate RS232C baud rate Page SCSI ID Product ID Pre-pick Page Pick start time Manual feed timeout Manual Feed Timeout 10 S Manual Feed Timeout Paper pick retry Page Paper feed retry Page Function key Page Setup mode lock Setup Mode Lock Page Activating the Test Mode <<TEST MODE>> T Please wait SETUP BROWSE TEST SETUP BROWSE TEST <<TEST MODE>> Offline Feed Test Mode selection (power on with MENU pressed) 6-48 * Turn off to quit <<MODE SELECT>>. : Cursor buttons : Blinking Contents of the Test Mode Offline feed test Page Options Device life GLOSSARY OF TERMS Page Page Page Page Page Page INDEX A C B D O P G H I M S T U R