![](/images/new-backgrounds/1172843/172843159x1.webp)
2 | 4 | 6 | 8 | 10 | 12 | 14 | 16 | 18 | 20 | 22 | 24 |
1 | 3 | 5 | 7 | 9 | 11 | 13 | 15 | 17 | 19 | 21 | 23 |
Terminator power supply: Supply (LED signal)
(IDD Reset signal) N.C.
Force Single Ended: LVD mode
Force Narrow:
Motor start mode
Write protect: enabled
SCSI ID #15
Figure 5.3 CN2 setting terminal (on NP models only)
5.3.1SCSI ID setting (NP model only)
Table 5.1 shows the SCSI ID setting. Refer to Figures 5.2 and 5.3 for terminal positioning and allocation.
IMPORTANT
When the SCSI ID is set using the external operator panel connector CN1, all pins listed in Table 5.1 should be open. If any of pins are shorted, unexpected SCSI ID is set.
|