Fujitsu MAX3147RC, MAX3036RC, MAX3073RC manual Standard Features

1.1 Standard Features

When Write Cache is enabled, you should ensure that the cached data is surely flushed to the disk media before you turn off the drive's power.

To ensure it, you should issue either the SYNCHRONIZE CACHE command or the STOP UNIT command with specifying “0” to the Immediate bit, and then confirm that the command is surely terminated with the GOOD STATUS.

(9)Command queuing feature

The HDDs can queue maximum 128 commands, and optimizes the issuing order of queued commands by the reordering function. This feature realizes the high speed processing.

(10)Reserve and release functions

The HDDs can be accessed exclusively in the multi-host or multi-INIT environment by using the reserve and release functions.

(11)Error recovery

The HDDs can try to recover from errors in the disk drive using its powerful retry processing. If a recoverable data check occurs, error-free data can be transferred to the INIT after being corrected in the data buffer. The INIT software is released from the complicated error recover processing by these error recovery functions of the HDDs.

(12)Automatic alternate block reassignment

If a defective data block is detected during read or write the HDDs can automatically reassign their alternate data block.

(13)Programmable data block length

Data can be accessed in fixed-block length units. The data block length is programmable, and can be specified at initializing with a multiple of four within the range of 512 to 528 bytes.

Error rate increase

1.The drive format at factory shipment is generally 512 bytes.

2.The recoverable Error of the drive might increase when the format would be modified from 512 bytes to the following values:

516 bytes, 520 bytes, 524 bytes, 528 bytes.

3.The recoverable Error referred here is sense data (1-13-xx).

C141-E237 1-3