MB3887
(7) PWM comparator block (PWM Comp.)
The PWM comparator circuit is a
The PWM comparator circuit compares the triangular wave generated by the triangular wave oscillator to the error amplifier output voltage and turns on the external output transistor during the interval in which the triangular wave voltage is lower than the error amplifier output voltage.
(8) Output block (OUT)
The output circuit uses a
The output “L” level sets the output amplitude to 6 V (Typ) using the voltage generated by the bias voltage block (VH) .
This results in increasing conversion efficiency and suppressing the withstand voltage of the connected external transistor in a wide range of input voltages.
(9) Control block (CTL)
Setting the CTL terminal (pin 14) low places the IC in the standby mode. (The supply current is 10 ∝A at maximum in the standby mode.)
CTL function table
CTL | Power | OUTD |
|
|
|
L | OFF (Standby) | |
|
|
|
H | ON (Active) | L |
|
|
|
(10) Bias voltage block (VH)
The bias voltage circuit outputs VCC −6 V (Typ) as the minimum potential of the output circuit. In the standby mode, this circuit outputs the potential equal to VCC.
2. Protection Functions
Under voltage lockout protection circuit (UVLO)
The transient state or a momentary decrease in supply voltage or internal reference voltage (VREF) , which occurs when the power supply (VCC) is turned on, may cause malfunctions in the control IC, resulting in breakdown or degradation of the system.
To prevent such malfunction, the under voltage lockout protection circuit detects a supply voltage or internal reference voltage drop and fixes the OUT terminal (pin 20) to the “H” level. The system restores voltage supply when the supply voltage or internal reference voltage reaches the threshold voltage of the under voltage lockout protection circuit.
Protection circuit (UVLO) operation function table
When UVLO is operating (VCC or VREF voltage is lower than UVLO threshold voltage.)
OUTD | OUT | CS |
|
|
|
H | L | |
|
|
|
17
