Fig. 1 Indoor Unit
1Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
●When kept on pressing the MANUAL AUTO button for more than 10 seconds, the forced cooling operation will start.
●The forced cooling operation is used at the time of installation.
Only for authorized service personnel’s use.
●When the forced cooling operation starts by any chance, press the START/STOP but-
ton to stop the operation.
3Indicator (Fig. 3)
4Remote Control Signal Receiver
5 OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)
●If the TIMER indicator lamp flashes when the timer is operating, it indicates that a fault has occurred with the timer setting
(See Page 15 Auto Restart).
7SUPER QUIET Indicator Lamp (orange)
8Intake Grille (Fig. 4)
9 Front Panel
0 Air Filter
A Air Flow Direction Louver B Power Diffuser
C
(behind Air Flow Direction Louver) D Drain Hose
E Air Cleaning Filter
Fig. 5 Outdoor Unit
FIntake Port G Outlet Port H Pipe Unit
I Drain port (bottom)
Fig. 6 Remote Controller 
JSLEEP button
KMASTER CONTROL button L SET TEMP. button ( 
/ 
) M Signal Transmitter
N TIMER MODE button
O TIMER SET ( 
/ 
) button P FAN CONTROL button
Q START/STOP button R SET button (Vertical) S SET button (Horizontal) T SWING button
U RESET button
VTEST RUN button
●This button is used when installing the conditioner, and should not be used under normal conditions, as it will cause the air conditioner’s thermostat function to oper- ate incorrectly.
●If this button is pressed during normal operation, the unit will switch to test opera- tion mode, and the Indoor Unit’s OPERA- TION Indicator Lamp andTIMER Indicator Lamp will begin to flash simultaneously.
●To stop the test operation mode, press the START/STOP button to stop the air condi- tioner.
WCLOCK ADJUST button
XRemote Controller Display (Fig. 7) Y Transmit Indicator
Z Clock Display
[ Operating Mode Display \ Timer Mode Display ] Fan Speed Display
` Temperature SET Display a SLEEP Display
b SWING Display
9315345363_OM.indb Sec1:4
En-4
9/16/2010 2:48:48 PM
