ACCESSORIES
CHECKING ACCESSORIES
One connector cover | One remote control |
One strap | Two AA batteries | One user’s manual |
(for remote control) | (for remote control) |
|
|
| Manual |
English
Four safety brackets
(types A x 2, type B x 2)
Four screws
(screw A x 2, screw B x 2, for brackets that prevent the unit from falling over)
Screw A (10 mm)
Screw B (20 mm)
Two ferrite cores | Two cable clampers Three power cables | ||||||
(with wire clampers) |
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
HOW TO USE ACCESSORIES
Cable clampers
Use the supplied cable clampers to bind the display’s signal or power cables. Use them as shown in the figure when mounting the display on the wall, using the
When you run signal cables | When you run signal cables to the right |
downwards |
|
Connector cover
When you finish binding the cables using the cable clampers, you need to attach the connector cover to the display.
To do this, use nippers to cut out a section of the connector cover such that the cables can be pulled out through that section. Then attach the cover to the display.
When attaching the connector cover, make sure that the upper and lower projections on the cover fit properly into the corresponding sections on the display.
Projections (to be fit into corresponding sections on the display)
Information
Cables for connecting the display to external equipment are not supplied. Contact your dealer for more information on these products.