Fujitsu S6110 Primary Master Submenu of the Main Menu, Auto, Enter, Menu Field, Options, Default

L i f e B o o k S S e r i e s N o t e b o o k B I O S

Primary Master Submenu of the Main Menu

The Primary Master submenu identifies what ATA devices are installed.

Note that actual hard drive label shown may vary. Depending on the drive type, information such as cylin- ders, heads and sectors may also be displayed.

PhoenixBIOS Setup Utility

Main

Primary Master [TOSHIBA MK4018GAP -(PM)]		Item Specific Help
Type:	[Auto]	Select ATA/ATAPI drive
Maximum Capacity:	40008MB	installed here.
Multi-Sector Transfers:	[16 Sectors]	[Auto]
LBA Mode Control:	[Enabled]	The BIOS auto-types the
PIO Transfer Mode:	[Fast PIO 4]	drive on boot time.
DMA Transfer Mode:	[Ultra DMA 5]
		Except [Auto]
		You enter parameters of
		the drive.
		[None]
		The drive is disabled.

F1	Help	Select	Item
ESC	Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 2. Primary Master Submenu

Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu

Menu Field	Options		Default	Description
Type:	■	Auto	[Auto]	Selects the ATA/ATAPI device type. Select Auto to have the type auto-
	■	None		matically identified by the BIOS at POST. If None is selected, all of the
	■	CD-ROM		following Set-up items do not appear. Select CD-ROM if a CD-ROM
	■	SuperDisk		drive is installed at this connection. Select SuperDisk if a SuperDisk drive
	■	Hard Disk		is installed at this connection. If Hard Disk is selected, you must specify
				the number of Cylinders, Heads, and Sectors for the drive.
Cylinders:	■	A number between	–—	This item appears only when Hard Disk Auto is selected. This field is
		0 and 65,535		changed by incrementing (pressing the [Spacebar]) or by typing in the
				number.
Heads:	■	A number between	–—	This item appears only when HArd Disk. This field is changed by incre-
		1 and 16		menting (pressing the [Spacebar]) or by typing in the number.
Sectors:	■	A number between	–—	This item appears only when Hard Disk is selected. This field is changed
		0 and 63		by incrementing (pressing the [Spacebar]) or by typing in the number.
Maximum	■	Display only	–—	Displays the maximum capacity of the drive calculated from the parame-
Capacity:				ters of the hard disk when Auto or Hard Disk are selected.

6