L i f e B o o k i S e r i e s B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies which ATA devices are installed.
Note that, although Auto is the default setting for this
submenu, the Hard Disk setting is illustrated, since it contains all of the menu fields.
Note that actual hard drive label shown may vary.
PhoenixBIOS Setup Utility
Main
|
|
|
|
|
| Primary Master [TOSHIBA | Item Specific Help |
| |
|
|
|
|
|
| Type: | [Hard Disk] | Select ATA/ATAPI drive |
|
| Cylinders: | [16383] | installed here. |
|
| Heads: | [16] |
|
|
| Sectors: | [63] | [Auto] |
|
| Maximum Capacity: | 8455MB | The BIOS |
|
|
|
| drive on boot time. |
|
| [16 Sectors] |
|
| |
| LBA Mode Control: | [Enabled] | Except [Auto] |
|
| PIO Transfer Mode: | [Fast PIO 4] | You enter parameters of |
|
| DMA Transfer Mode: | [Ultra DMA 2] | the drive. |
|
|
|
| [None] |
|
|
|
| The drive is disabled. |
|
|
|
|
|
|
|
|
|
|
|
F1 | Help | Select | Item |
ESC | Exit | Select | Menu |
Change | Values | |
Enter | Select | ▲ |
F9 Setup Defaults
F10 Save and Exit
Figure 2. Primary Master Submenu
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field | Options | Default | Description | |
|
|
|
|
|
|
|
|
|
|
Type: | ■ | Auto | [Auto] | Selects the ATA/ATAPI device type. Select Auto to have the type |
| ■ | None |
| automatically identified by the BIOS at POST. If None is selected, all |
| ■ |
| of the following | |
| ■ | Hard Disk |
| |
|
|
|
| selected, you must specify the number of Cylinders, Heads, and |
|
|
|
| Sectors for the drive. |
|
|
|
|
|
Cylinders: | ■ | A number | This item appears only when Hard Disk is selected. When Hard Disk | |
|
| between 0 |
| is selected, you can change the value. This field is changed by |
|
| and 65,535 |
| incrementing (pressing the [Spacebar]) or by typing in the number. |
|
|
|
|
|
Heads: | ■ | A number | This item appears only when Hard Disk is selected. When Hard Disk | |
|
| between 1 |
| is selected, you can change the value. This field is changed by |
|
| and 16 |
| incrementing (pressing the [Spacebar]) or by typing in the number. |
|
|
|
|
|
Sectors: | ■ | A number | This item appears only when Hard Disk is selected. When Hard Disk | |
|
| between 0 |
| is selected, you can change the value. This field is changed by |
|
| and 63 |
| incrementing (pressing the [Spacebar]) or by typing in the number. |
|
|
|
|
|
6