Initial start-up Operating Pocket LOOX 600
A26391-K120-Z120-1-7619 15
Starting Pocket LOOX 600 the first time
Actuate General Reset switch
The first time you start your Pocket LOOX 600, you must actuate the General Reset switch. The
General Reset switch is located on the bottom edge under a sliding cover.
!Only actuate the General Reset switch during the initial start-up. To switch the Pocket PC
on or off after the initial start-up, briefly press the Suspend button.
If the device is switched off with the General Reset switch, the battery is swit c hed off so
that the RAM contents are lost. This means you loose all data (documents, additionally
installed programs, personal settings) that you haven't saved elsewhere.
Therefore, remember to make a regular data backup with synchronisation (see the
chapter "Synchronising data with ActiveSync") or on corresponding memory cards
(available as an accessory). The program LX Backup is provided on your Pocket LOOX
600 for completely backing up the RAM memory.
1
2
3
Ê Slide the cover all the way to the right with
the stylus (1) so that the General Reset
switch is accessible.
Ê Also press the switch to the right with the
stylus (2): your Pocket PC will start up after
a few seconds.
Ê Slide the cover closed again (3).
i
After approximately 10 seconds a picture appears on the display and a tone sounds.
Adjusting touchscreen
The display of your Pocket PC is a touchscreen. To ensure that the touchscreen of your Pocket P C
reacts correctly when touched with the stylus, you will be asked to align the touchscreen after the
initial start-up.
Touch the centre of the cross hairs that appears on the display with the stylus. This procedure mus t
be repeated several times, whereby the cross hairs appear at different locations on the display each
time. Follow the instructions on the display.