FUNAI BLC320EM9 owner manual Watching TV, 5Channel Selection, 5Volume Adjustment, 5Sleep Timer

WATCHING TV

INTRODUCTION

5Channel Selection

Select channels by pressing [CH. K/L] or [the Number buttons].

•To select the memorized channels, use [CH. K/L] or [the Number buttons].

•To select the non-memorized channels, use [the Number buttons].

To Use [the Number buttons]

TV

- When selecting analog channel 12

5Volume Adjustment

This section describes how to adjust the volume. The mute function, which turns the sound off and on, is also described.

Use [VOL. X/Y] to adjust the audio volume.

or Volume 20

•The volume bar will be displayed at the bottom of the TV screen when adjusting the volume.

•The volume bar will automatically disappear in a few seconds.

Press [MUTE ] to turn off and on the sound.

PREPARATION INITIAL SETTING

DTV

-When selecting digital channel 12-1

Be sure to press [–]before entering the minor channel number.

•Press [CH. RETURN ] to return to the previously viewed channel.

About digital TV broadcasting:

With its high definition broadcast, digital broadcasting far surpasses analog broadcasting in both its picture and sound quality.

What is the minor channel?

By using high compression technology, digital broadcasting offers a service that enables multiple signals to send simultaneously.

Therefore, you can select more than one program per major channel since digital broadcasting technology distinguishes between multiple channels broadcast by a single network.

Mute

•“Mute” is displayed on the TV screen for a few seconds.

Press [MUTE ] again or [VOL. X/Y] to recover the original volume.

5Sleep Timer

The sleep timer can be set to automatically turn off the unit after an incremental period of time.

1Press [SLEEP ] to set the sleep timer.

SleepOff

• Sleep timer display appears on the TV screen.

WATCHING TV OPTIONAL SETTING TROUBLESHOOTING

NTSC (analog mode)

CH4

[Air Time]

18:00

18:30

19:00

19:30

20:00

20:30

ATSC (digital mode)

CH4 No signal No signal

CH4

(high definition TV)

CH4	CH4-1	No signal
CH4	No signal	CH4-2
CH4	CH4-1	CH4-2

2Press [SLEEP ] repeatedly to change the amount of time until shut off.

Sleep 120min.

•You can set your unit to turn off after a set period of time (from 30 to 120 minutes).

•Each press of [SLEEP ] will increase the time by 30 minutes.

•After setup, the sleep timer display can be called up for checking by pressing [SLEEP ].

INFORMATION

	minor channel
major channel
: change automatically
: change manually by using [CH. K/ L]

Note:

•“No Signal” will appear on the TV screen after the minor channel broadcast is over.

•“Audio only program“ message will appear on the TV screen, when you receive only sound signal.

To Cancel the Sleep Timer

Press [SLEEP ] repeatedly until “Sleep Off” is displayed on the TV screen.

Note:

•The sleep timer display will automatically disappear in a few seconds.

•When you disconnect the unit from the AC outlet or when a power failure occurs, the sleep timer setting will be canceled.

15

EN