FUNAI BLC320EM9 5Attaching the Stand, 5Symbols Used in this Manual, 5Trademark Information

INTRODUCTION

5Attaching the Stand

You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.

Spread a thick and soft cloth over a	Insert the stand all the way to the	Drive Phillips pan screws in the 3
1 table.	2 main unit slowly until it clicks.	3 threaded holes at the bottom of the
Place the main unit face down onto it.	Make sure not to put the AC cord	stand with a screwdriver tightly.
Make sure not to damage the screen.	between the stand and the unit.
At least two people are required at		screw holes
this step.		1

f r ont

sid

e

lever

To Remove the Stand from this Unit

Unscrew the Phillips pan screws indicated by “ 1 ”, then lift the lever on the bottom stand and remove the stand from the unit slowly. Be careful not to drop the stand when you remove it.

Note:

•When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.

•Make sure to use a table which can support the weight of this unit and is larger than this unit.

•Make sure the table is in a stable location.

5Symbols Used in this Manual

The following is the description for the symbols used in this manual.

Description refers to:

DTV : Digital TV operation

TV : Analog TV operation

• If neither symbol appears under the function heading, operation is applicable to both.

5Trademark Information

•HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.

•Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories.

•Products that have earned ENERGY STAR® are designed to protect the environment through superior energy efficiency.

4

EN