FUNAI CR320IL8 A owner manual 5Switching Each Mode, 5Switching Audio Mode

5Switching Each Mode

You can easily switch with the remote control to the DTV (ATSC) and TV (NTSC) or to access an external device when they are connected to the unit.

Press [DTV/TV] repeatedly to change the analog TV or the digital TV.

5Switching Audio Mode	INTRODUCTION
This section describes how to switch the audio in the analog mode and how
to switch the audio language in the digital mode.
TV
	CONNECTION
While receiving an MTS broadcast, press [AUDIO]
repeatedly to cycle through the available audio
channel.

DTV / TV

Note:

ANALOG MODE

DIGITAL MODE

AUDIO	MAIN
	SAP
		INITIAL
	MONO
MAIN	: Outputs main-audio	SETTING

•When you switch the analog mode to the digital mode, it may take a while until the digital channel selection is completed. The following TV screen is displayed while switching the mode.

NOW SCANNING

Press [INPUT SELECT] repeatedly to cycle through the input modes.

	ANALOG MODE
	DIGITAL MODE
INPUT	VIDEO1
SELECT
	VIDEO2
	COMPONENT

•To use the video (rear) or S-video input jack on the unit, select “VIDEO1”.

•To use the video (front) input jack on the unit, select “VIDEO2”.

•To use the component video input jack on the unit, select “COMPONENT”.

SAP	: Outputs second audio program
MONO	: Outputs mono-audio

•The information display will automatically disappear in a few seconds.

1 Press [AUDIO] to display the currently selected				WATCHING
DTV
language and the number of available languages.				TV
		KABC	CH 95-03
		A Day of Memories
	AUDIO	ENGLISH 1/3		OPTIONAL SETTING
2 Press [AUDIO] repeatedly to cycle through the
available audio languages.				TROUBLESHOOTING
	AUDIO
• Available languages differ depending on the
	broadcast. “OTHER” is displayed when the audio
	language cannot be acquired, or the acquired languages
	are other than English, Spanish or French.			INFORMATION
• The information display will automatically disappear
	in a few seconds.
	Note:
	• Pressing [AUDIO] does not control external audio device.

13

EN