FUNAI MSD520FF TV Operation and Settings, Watching a TV Program, Degaussing, Picture Control

VOLUME 20

TV SECTION

TV OPERATION AND SETTINGS

WATCHING A TV PROGRAM

TV

1Plug in the unit power cord

Plug the unit power cord into a standard AC outlet.

NOTE:

•If any digits appear in the corner of the screen, hit [STANDBY-ON]without unplugging the power cord.

2Turn on the unit

Hit [STANDBY-ON]to turn on the unit.

3Select the channel number

Press [CH. K / L] or the Number buttons to select your desired channel number.

Notes for using the Number buttons:

¡You must precede single-digit channel numbers with a zero (for example: 02, 03, 04 and so on).

¡When selecting cable channels which are higher than 99, hit [+100] first, then press the last two digits. (Example: to select channel 125, first hit [+100] then hit [2] and [5].)

4Adjust sound

Press [VOL. K / L] to adjust the volume.

Hit [MUTE] to instantly mute the

sound.C C C C C C C C C C C C C C C C

Hit it again to restore the previous sound level.

NOTE:

•If you press [CH. K / L] in the DVD mode, you can change the TV channels. Even if you turn off the unit in the DVD mode, when you turn it on again, it will go into the TV mode.

TO WATCH CABLE OR SATELLITE CHANNEL

•If the unit is connected to a cable box or satellite box, press [CH. K / L] to select CH3 or CH4 according to the output channel setting of the device and select desired channel on that device.

TO WATCH EXTERNAL INPUT

•When an external equipment is connected to the front AUDIO/VIDEO input jacks, press [SELECT] or [CH. K / L] repeatedly until “AUX” appears on the screen.

DEGAUSSING

TV

This television has a degaussing circuit that will clear up color errors on the TV screen that are caused by any excess magnetism which happens to get too close to the TV. This circuit is designed to operate once when the set is first plugged in. If minor color errors are seen in some locations on the screen, please unplug the TV for approximately 30 min- utes. When the TV is plugged back in, the degauss- ing circuit will operate once to clear them up. Repeat this procedure any time the TV screen is accidentally magnetized or when the TV is moved or relocated.

PICTURE CONTROL

TV

The unit’s picture controls – BRIGHT, CON- TRAST, COLOR, TINT and SHARPNESS – are preset to factory specifications. Although they are usually the best, you may need to make some further adjustments for a more natural looking image.

Make sure ...

•The unit must be turned on.

1Call up the menu

Hit [PICTURE].

2Select item you want to adjust

Press [K / L] until desired control is displayed.

BRIGHT CONTRAST COLOR

TINT	BRIGHT
SHARPNESS	– P P P P P P P C P P P P P P P +

3Adjust the setting

Press [s / B] to adjust to your desired level within 5 seconds.

	s	B
BRIGHT	to decrease	to increase
	brightness	brightness
CONTRAST	to decrease	to increase
	contrast	contrast
COLOR	to pale	to brilliant
TINT	to purple	to green
SHARPNESS	to soft	to clear

•Even if there is a power failure of any kind, the unit will retain its memory for this feature.

- 13 - EN