SERIES II 20 amp Power ConditionerS
carefully before using.
WA R N I N G
To reduce the risk of electrical shock, do not expose this equipment to rain or moisture.
Dangerous high voltages are present inside the
enclosure. Do not remove the covers. Refer servicing to qualified personnel only. The lightning flash with an arrowhead symbol, is intended to alert the user to the presence of
product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
I M P O R TAN T SAF E TY I N S T R U C T I O N S
(Please read prior to installation)
1.Please read and observe all safety and operating instructions before installing your Series II unit. Retain these instructions for future reference.
2.Your Series II unit should not be used near
water – for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, near a swimming pool, etc.
3.Do not place your Series II unit near heat sources such as radiators, heat registers, stoves, or other appliances that produce heat.
4.The
versions 100 – 120 VAC 50 Hz.)
5.Route the power cord and other cables so that they are not likely to be walked on, tripped over, or stressed. Pay particular attention
to the condition of the cords and cables at the plugs, and the point where they exit your Series II unit. To prevent risk of fire or injury, damaged cords and cables should be replaced immediately.
6.Clean your Series II unit with a damp cloth only. Do not use solvents or abrasive cleaners. Never pour liquid on or into the unit.
7.Your Series II unit should be serviced by qualified service personnel when:
•The power supply cord or the plug has been frayed, kinked, or cut.
•Objects have fallen or liquid has spilled into the unit.
•The unit has been exposed to rain or other moisture.
•The unit does not appear to operate normally.
•The “Protection OK” indicator is not lit.
•The unit has been dropped, or the enclosure has been damaged.
•The retractable LED lights have failed. (not
applicable to the
8.Your Series II unit requires that a safety ground be present for proper operation. Any attempt to operate the unit without a safety ground is considered improper operation and could invalidate the warranty.
3
