Mounting Considerations
The Integrator unit is mounted on any flat surface, using two #6 screws provided, through the mounting holes in the case. The unit should be located so its LED is visible to the helmsman during normal boat operation, but not directly in the line of vision due to the brightness of the LED. Although the Integrator is a completely sealed unit it should be mounted in a location that is not subject to immersion or water from wash down.
Installation
Installation of The Integrator consists of mounting the device in a suitable location, connecting wiring for NMEA input and AD10 output signals, and providing a switched 12 volt power supply and ground.
NMEA Out | Red ( + ) | Red ( + ) | Red ( + ) | Switched | ||
{ Black ( - ) | Black ( - ) | |||||
| Black ( - ) | 12 V Pwr | ||||
Gladiator |
|
|
|
| Source | |
Compass |
|
|
|
|
| |
Ball |
|
|
|
|
| |
|
|
| Integrator | Connects To |
| |
|
|
| Wire Color |
| ||
|
|
|
|
| ||
|
|
| Orange AD10 Clock + Furuno Clock + (Yellow) |
| ||
|
|
| Green Ad 10 Clock - _ Furuno Clock - (Green) |
| ||
|
|
| Blue AD 10 Data + | Furuno Data + (White) |
| |
|
|
| Brown AD 10 Data - | Furuno Data - (Black) |
| |
Connector | Wire Color | Signal | Connects To |
| ||
Power |
| Red | + 12 VDC | Switched Power Source |
| |
|
| Black | Ground | Engine Ground |
| |
NMEA 0183 | Red | NMEA + | Gladiator NMEA Out + (Red) |
| ||
|
| Black | NMEA - | Gladiator NMEA Out - (Black) |
| |
AD10 |
| Orange | AD10 Clock + | Furuno Clock + (Yellow) |
| |
|
| Green | AD 10 Clock - | Furuno Clock - (Green) |
| |
|
| Blue | AD10 Data + | Furuno Data + (White) |
| |
|
| Brown | AD 10 Data - | Furuno Data - (Black) |
|
Radar/Chartplotter MARPA Configuration
The radar or plotter should be configured for magnetic oriented AD10 data when using the
Page 3