Fusionbrands MS-AB108 Wiring, Be sure to use the supplied power extension cable, RCA cable

v 1.0

WIRING

Be sure to use the supplied power extension cable.

»Connect the ground wire (Black wire) to the negative of the vessel (Ground) Note: clean dirt, corrosion and paint to bare metal.

»Connect the 12 volt (red wire) to the positive battery terminal of the vessel; Make sure the fuse is close to the battery.

»Connect the remote on (blue wire) to the remote turn on lead of the Headunit. - If your head unit does not have a remote turn-on lead, connect a switched 12v power lead to the unit.

»Connect the RCA cables to source

»Check all connections.

»Finally, connect the power plug end of the power harness to the unit.

RCA cable

Connect to subwoofer pre-out on source.

LOW INPUT	LEVEL	L.P.F
LEFT		FUSE
		POWER
		REM
		+12 GND
RIGHT	MIN MAX	30Hz 250Hz

MS-AB108

Connect red wire to positive (+12V) battery terminal

Connect blue wire to source unit’s accessory lead or switched 12 volt source (Remote)

Power Plug

Connect black wire to negative of vessel (Ground)

Fuse

+12 Vessel Battery

www.fusionelectronics.com

PUBLISHED BY FUSION ELECTRONICS LIMITED: © Copyright 2009 by FUSION Electronics Limited. All rights reserved. Specifications and design are subject to change without notice.

YOU CAN HELP PROTECT THE ENVIRONMENT! Please remember to respect the local regulations: Hand in the non-working electrical equipment to an appropriate waste disposal center.