Page 8 | PSW112 Owners Manual | |
|
|
|
Subwoofer Controls
Your PSW112 subwoofer has several controls that allow you to configure the unit to reflect your personal music tastes. All controls are found on the back of the unit.
vFrequency Adjust – This adjusts the upper frequency range of the subwoofer. A typical setting when using the subwoofer with the MNCX Platinum
vAuto Power – The subwoofer can be set up with two different power configurations:
oAuto Power On – The subwoofer will power down a few minutes after the signal is removed and it will turn on immediately when it receives a signal.
oAuto Power Off – The subwoofer is constantly on if the unit is powered up.
v Volume Control – The volume control should be set to the desired bass level for the system.
vPhase – The Phase switch is set for the best bass sound. Switch between the 0 and 180 position until the bass is the loudest. In some applications, there may be no noticeable difference and in this case leave the switch in the 0 position.
| M&S Systems | Page 5 |
|
|
|
|
|
|
Connecting Your Subwoofer
First, turn off power to your entire system to prevent accidents such as short circuits from damaging your equipment.
The PSW112 subwoofer can be connected to your system using one of three methods. The method you select is based on the configuration of your system.
1.Amplifier with a subwoofer output connection – If your system has a subwoofer output connection, use an RCA type connector to connect the PSW112 subwoofer to your receiver. A shielded audio cable is required for this setup with a
2.Separate