INSTALLATION
13) Carefully remove the bottom brick panel. | 17) Disconnect the 2 connectors from the | 20) Disconnect the black and red wires from |
| modulating coil. | the solenoid valve. |
INSTALLATION
Bottom Brick Panel
14)Loosen the 2 screws that hold the right side heat shield.
Heat
Shield
15)Lift up and pull out the heat shield slightly to clear the head screws and then hang it on the top bracket (located directly above the heat shield).
Bracket
Heat
Shield
18)Remove the DC Sparker wires; 1 wire for the ignitor and 2 wires to the module box.
19)Remove the 16 screws that hold the valve tray to the firebox and slightly pull out the valve tray.
Valve Tray
21)Disconnect the 2 red wires and 1 black wire from the valve.
Modulating Coil
Wires
22)Completely pull out the valve tray.
23)Replace the front burner orifice with orifice #56. See image below. Use another wrench to hold onto the elbow behind the orifice.
24)Replace the back burner orifice with orifice #53. See image below. Use another wrench to hold onto the elbow behind the orifice.
Front Burner | Rear Burner |
Orifi ce | Orifi ce |
16)Disconnect the inlet gas line from the valve.
Valve Tray Slightly Removed
32 | Regency® L676 Direct Vent Gas Fireplace |
