INSTALLATION
6) Replace the front burner orifice with orifice | 10) Remove the NG pilot orifice with the Allen | 14) Disconnect the 2 grey connectors from |
#56. See image below. Use another wrench | Key and replace with LP pilot orifice. | the modulator coil. |
to hold onto the elbow behind the orifice. |
|
|
7)Replace the back burner orifice with orifice #53. See image below. Use another wrench to hold onto the elbow behind the orifice.
Front Burner | Rear Burner |
Orifi ce | Orifi ce |
11)
12) Loosen the 2 screws that hold the right | 15) Remove the right side panel by undoing the | |
9 screws. | ||
side heat shield. | ||
|
INSTALLATION
8)Remove the pilot shield by removing the 2 screws.
Pilot
ShieldHeat
Shield
13) Lift up and pull out the heat shield slightly to clear the head screws and then hang it on the top bracket (located directly above the heat shield).
9)Remove the clip from the pilot head assembly
using a flat head screw driver. | Bracket |
Clip
Heat
Shield
16)Using a Torx T20, remove and discard the 3 pressure regulator mounting screws. Remove the modulator coil and the gasket.
Regency® L676 Direct Vent Gas Fireplace | 29 |
