v 1.0
MARINE ACTIVE SUBWOOFER
MS-AB108
SPECIFICATIONS
MAX POWER RATING | 210 Watts |
FREQUENCY RESPONSE | 30Hz – 250Hz |
LOW PASS FILTER (VARIABLE) | 30Hz – 250Hz |
TUNING | Bass Reflex |
WOOFER SIZE | 8” down firing |
FUSE | 10 Amp |
DIMENSIONS | Length 515mm - 20 1/4” |
| Width 233mm - 9 3/16” |
| Height 190mm - 7 1/2” |
PRODUCT CONTENTS
1x
1x Power / GND/
1x RCA Cable Mounting Hardware Manual Warranty Card
CONTROL DESCRIPTIONS
LEVEL
INSTALLATION
»Make sure the Marine Active Enclosure is firmly secured.
»Check before drilling or cutting holes.
»DO NOT work near gas tanks, fuel lines, hydraulic lines or electrical wiring.
»DO NOT mount the Marine Active Enclosure in such a way as to pinch or damage the wires.
»Make sure everything is firmly connected, before attaching the +12V wire. Make sure the +12V wire is fused as close as possible to the battery. ALWAYS use a fuse with the recommended rating.
(Wiring diagram on reverse)
RECORD YOUR PURCHASE DETAILS HERE:
MODEL NUMBER
DATE OF PURCHASE
AFFIX RECEIPT HERE
This allows the adjustment of the amplifier input level. Turn clockwise to increase the level. If the sound becomes distorted reduce the level.
LOW PASS FILTER (LPF)
This allows the adjustment of the highest frequency the Marine Active Enclosure will produce.
This should be adjusted to blend with your main speakers. Typically, this will be set to around 100Hz (approximately the central position of the control knob).
WARNING! Audio Systems can produce sound levels over 135dB. Continuous exposure to sound pressure levels over 100dB may cause permanent hearing loss!
www.fusionelectronics.com
PUBLISHED BY FUSION ELECTRONICS LIMITED: © Copyright 2009 by FUSION Electronics Limited. All rights reserved. Specifications and design are subject to change without notice.
YOU CAN HELP PROTECT THE ENVIRONMENT! Please remember to respect the local regulations: Hand in the