Note:
After switching on, the
This situation can occur if:
-the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the
-the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap in the input connector.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to ensure proper transmission on the DMX data link.
Control channel 1 - Horizontal movement (Pan)
Push slider up in order to move the mirror horizontally (PAN).
Gradual mirror adjustment from one end of the slider to the other
DMX-value Feature
Gradual adjustment of the mirror position from left to right
Control channel 2 - Vertical movement (Tilt)
Push slider up in order to move the mirror vertically (TILT).
Gradual mirror adjustment from one end of the slider to the other
Gradual adjustment of the mirror position from down to up
Control channel 3 - Colour-wheel
Linear colour change following the movement of the slider. In this way you can stop the
| Feature |
White | |
Dark blue | |
Pink | |
Light green | |
Orange | |
Light blue | |
Yellow | |
127 | Cherry red |
Forwards rainbow effect with increasing speed | |
Backwards rainbow effect with increasing speed | |
Control channel 4 - Rotating |
Feature |
| |
Open |
| |
Rot. gobo 1 | ||
Rot. gobo 2 | ||
Rot. gobo 3 | ||
Rot. gobo 4 | ||
Rot. gobo 5 | ||
Rot. gobo 6 | ||
Rot. gobo 7 | ||
Forwards | ||
Backwards |
13/1551839250X62NXS_V_1_1_E.DOC