Filling the engine with engine oil:
ATTENTION!
Damage to the engine!
vThe engine must be filled with oil before starting.
8. Trouble-Shooting
DANGER!
Danger of physical injury from the blade bar!
GB
ö
See the enclosed engine | l |
operating instructions. | |
1. Unscrew the oil cap l. |
|
2. Fill with approx. 0.6 l engine |
|
oil (SAE 30) (OIL). |
|
vBefore remedying faults wait for the blade bar to stop, wear suitable working gloves and remove the spark plug connector (see enclosed engine operating instructions).
GB
l
ö |
3. Screw the oil cap l on again. |
Adjust Bowden cable of the drive:
If the Bowden cable of the drive has moved due to wear, it can be adjusted.
46 VDA / 51 VDA
Filling the engine with petrol:
46 V / 51 VD
See the enclose engine operating instructions.
1.Undo the petrol cap ö.
2.Fill with petrol (at least 87 octane) (FUEL).
3.Do the petrol cap ö up again.
For further engine maintenance instructions see the enclosed engine operating instructions.
V
vTurn the adjusting nut V in the relevant direction
46 VD:
The adjusting nut is located on the
V
6
Cleaning the mower housing:
ä
Cleaning the collecting bag:
Cleaning the mulch unit:
Deposits make the starting process difficult, impair the quality of the cut and the discharge of the grass. Dirt and grass residues are easiest to remove immediately after mowing. The bottom should be cleaned on the grass to avoid getting the ground dirty.
1.Remove the mulch unit / collecting bag.
2.Fit the hose connection ä to the mower and turn the tap on.
3.Start the mower and switch off again after about 30 seconds. The rotating blade bar throws the water onto the bottom of the mower and thus cleans it.
4.Turn off the tap and remove the hose connection ä.
5.Clean the top with a cloth (do not use any sharp objects).
The collecting bag must be checked regularly for damage.
vRemove grass deposits from inside and outside the collecting bag at every mowing (do not use sharp objects).
vImmediately after mulching remove dirt and grass remains from the mulch unit (do not use any sharp objects).
46 VDA / 51 VDA
Adjust Bowden cable of the switch handle:
O
1
W 2
46 VDA / 51 VDA
Replacing the blade bar:
46 V
46 VDA / 51 VDA:
If the Bowden cable of the switch handle g has moved due to wear, it can be adjusted.
1.Detach attachment hook W.
2.Insert attachment hook W into hole 1 of the switch handle g.
A damaged or bent blade bar or a blade bar with broken off edges must be replaced because of the imbalance this causes. For imbalance reasons the blade bar must not be
Blade bars must only be replaced by GARDENA service department or by an authorised GARDENA dealer.
24 | 25 |
