|
| 3. Assembly |
GB |
| |
|
| |
|
|
|
Charging indicator lamp lights up red: | GB |
The battery is being charged. | |
Charging indicator lamp lights up green: |
|
Fitting the blower tube:
2
3
WARNING: Stop the unit and remove battery before attempting to install or remove the blower tube. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades.
1.Align the grooves on the blower tube 1 with the grooves on the blower outlet 2.
12. Push the blower tube onto the blower outlet until it snaps into place; tube is secured to blower by tube release button 3.
3.To remove the blower tube, press the tube release button 3 while pulling on tube.
The battery is fully charged. |
(For charging time, see 9. Technical Data) |
4.First disconnect the plug of the charging cable from the battery and then unplug the battery charger from the mains socket.
5.Push the battery from bottom onto the handle.
Avoid exhaustive discharge:
Do not wait until the blower comes to an absolute stop (battery totally discharged) as this shortens the battery life.
If the output of the blower decreases noticeably, charge the
battery .
If the battery has been totally discharged, the LED will flash at the start of charging. If the LED is still flashing after an hour, a fault has occurred (see 8. Troubleshooting).
4. Initial Operation
Charging the battery: |
| WARNING: Overvoltage damages batteries |
| ||
|
| and the battery charger. |
|
| Ensure the correct mains voltage. |
| ||
5. Operation
WARNING: Do not use the unit without the tube properly attached to avoid
4
Before using for the first time, the battery must be fully charged. Charging time (for uncharged battery) see 9. Technical Data.
When charging the battery, only use the GARDENA charger, art. no.
The
So that the fully charged battery is not discharged, the battery should be disconnected from the battery charger.
flying debris and/or impeller contact which can cause serious injury. Always wear gloves and use eye protection to prevent rocks or debris from being blown or ricocheting into the eyes and face which can result in blindness or serious injury.
Starting the blower:
0
Switching the blower on:
1. Push the battery onto the handle (see 4. Initial Operation).
2. Move the ON/OFF switch 0 to the ON (I) position.
6
5
1.Press the locking buttons 4 in and remove the battery 5 from the handle 6.
2.Plug the plug of the charger cable 7 into the battery 5.
3.Plug battery charger 8 into a mains socket.
Switching the blower off:
1. Move the ON/OFF switch 0 to the OFF (0) position.
2.Remove the battery from the handle (see 4. Initial Operation).
18 | 19 |
