INSTALLATION
Clearances
Models (M, MS, MST)(SRC, SR16) are for installation in non- combustible locations only with zero (0”) sides and rear clearance.
NOTE: Adequate clearance must be provided for servicing and proper operation.
Location
Counter salamanders should be installed on a firm, smooth and level base designed to withstand the weight of the fully laden appliance. Any openings in the wall behind or beside the appliance must be sealed.
Installation Instructions for
Range Mount Salamander
4
8 | 3 |
| |
| 6 |
| 7 |
2 | 5 |
"X" |
|
"X" | ~ |
1 |
|
1.Remove the front panel (5) by removing two (2), sheet metal screws from the underside of the salamander.
2.With the back panel, (4), still attached to the uprights (2&3) drop the uprights into the rectangular openings at the rear of the range (1).
3.Fasten the uprights, (2 & 3) to the range with four, (4), 5/16” x 18 bolts and flat washers. (6&7)
4.If the range is in a battery
5.Reattach the front panel (5) to the salamander with sheet metal screws previously removed.
Wall Mounted Salamanders
1.Each gas appliance must be located with respect to building construction and other equipment so as to permit access to the appliance, Such access and clearance may be necessary for servicing and cleaning.
2.Salamanders intended for wall mounting are shipped with the mounting kit already attached.
3.Provisions for gas connections, bottom or rear should be taken into consideration.
Statutory Regulations
When checking gas pressure be sure that all other equipment on the same gas line is on. A pressure regulator is supplied as standard equipment with Garland salamanders. Installation must conform to the National Fuel Gas Code ANSI Z223.1 or latest edition and/or local code to assure safe and efficient operation.
In Canada, the installation must comply with
NOTE: The appliance must be isolated from the gas supply piping system by closing it individual manual
Page 6 | Part # 1382684 Rev. 1 (02/11/11) |
