Garmin 190-01554-00_0C Introduction, Bark Correction, Device Overviews, Attaching the Dog Collar Device to the Collar Strap, Charging the BarkLimiter Deluxe Device, Rotating the Dial

Introduction

WARNING

See the Important Safety and Product Information guide in the product box for product warnings and other important information.

Device Overviews

BarkLimiter Device

Contact points

Mode and intensity dial

Status LED

BarkLimiter Deluxe Device

Contact points

Mode and intensity dial

Status LED

Charging clip contacts (BarkLimiter Deluxe model only)

Attaching the Dog Collar Device to the Collar Strap

1 With the buckle facing outward, insert the end of the collar

strap through the slot on the collar device.

2Pull approximately two-thirds of the collar strap through the slot.

3 Insert the end of the collar strap through the slot on the

opposite side of the device.

4Pull the strap until it is tight across the front of the device.

Charging the BarkLimiter Deluxe Device

NOTICE

To prevent corrosion, thoroughly dry the contacts on the collar and the surrounding area before connecting the charging clip.

Before you put the collar on the dog, remove the charging clip. If you do not remove the clip, it may become detached from the collar and become lost.

You should fully charge the battery before you use the device for the first time. Charging a fully depleted battery takes about two hours. The device will not charge when outside the temperature range of 32° to 104°F (0° to 40°C).

1 Snap the charging clip onto the device.

2Plug the small end of the power cable into the mini-USB port

on the charging clip.

3Plug the other end of the power cable into a power source. The status LED is solid red when the collar is charging.

4After the status LED turns solid green, remove the charging clip from the collar.

Turning On the Dog Collar Device

Rotate the dial away from N.

There is a 30-second delay before the device becomes active. The status LED indicates the battery charge level for five seconds and turns off. After an additional 25 seconds, the unit is active. The status LED flashes occasionally to indicate that the unit is detecting sound, motion, or vibration.

Turning Off the Dog Collar Device

Rotate the dial to N.

Rotating the Dial

NOTICE

Do not over-rotate the dial. The dial does not rotate past 7.

The dial is intentionally difficult to rotate. This helps to prevent accidental rotation while the device is in use on the dog.

Insert a coin or similar object into the slot to rotate the dial.

Bark Correction

When the device is active and properly fitted on the dog, it detects and corrects barks automatically. You can adjust the method and intensity of the corrections.

The status LED flashes briefly when the device detects motion or corrects a bark.

Short flash	Motion was detected, and no correction was applied.
Long flash	A bark was detected, and a correction was applied.

Introduction