Garmin 190-01554-00_0C Device Information, My dog is still barking, BarkLimiter Specifications, BarkLimiter Deluxe Specifications, Sleep Mode, Checking the Battery Charge Level

My dog is still barking

If the dog continues barking while wearing the device, you can try any of these options to improve the effectiveness of the device.

•Tighten the collar until it is very snug (page 2).

•Adjust the position of the device on the dog's neck (page 2).

•Wiggle the device to work the contact points through the dog's coat.

•Gradually increase the intensity level (page 2).

Device Information

BarkLimiter Specifications

Battery type	User-replaceable 3V CR2 lithium
	cylindrical

Battery life	6 months, typical use
Operating temperature	From 5° to 140°F (from -15° to 60°C)
range
Water resistance	IPX7

BarkLimiter Deluxe Specifications

Battery type	Rechargeable, replaceable lithium-ion
Battery life	3 months, typical use

Operating temperature range	From 5° to 140°F (from -15° to 60°C)
Charging temperature range	From 32° to 104°F (from 0° to 40°C)

Storage temperature range (up	From -4° to 122°F (from -20° to 50°C)
to 1 month)
Storage temperature range (up	From -4° to 104°F (from -20° to 40°C)
to 3 months)
Storage temperature range (up	From -4° to 68°F (from -20° to 20°C)
to 1 year)
Water resistance	IPX7

Sleep Mode

To conserve battery life, the device goes into sleep mode when no barks or motion are detected. The activity level of your dog affects the battery life of the device.

Checking the Battery Charge Level

Rotate the dial away from N.

The color of the status LED indicates the battery charge level for five seconds.

Green The battery has a good charge.

Yellow The battery should be charged or replaced soon.

Red	The battery should be charged or replaced immediately. Bark
	correction features are disabled.

BarkLimiter Battery Replacement

Instructions

WARNING

Do not use a sharp object to remove batteries.

CAUTION

Contact your local waste disposal department to properly recycle the batteries.

BarkLimiter Components

Back plate

Gasket

Battery

Polarity indicators

Replacing the BarkLimiter Battery

Before you replace the battery, you must remove all dirt, water, and debris from the device. You also need a small Phillips screwdriver.

You must replace the battery with a 3V CR2 lithium battery.

1Remove the four screws from the corners of the back plate.

2 Remove the back plate.

The battery comes out with the back plate.

3 Remove the battery.

4Install the new battery into the back plate according to the polarity indicators engraved on the back plate.

When properly installed, the battery snaps into the back plate.

5Verify that the gasket is not damaged and that it is completely seated in the groove.

6Replace the back plate.

7Replace the four screws to secure the back plate.

BarkLimiter Deluxe Battery Replacement Instructions

WARNING

This product contains a lithium-ion battery. To prevent the possibility of personal injury or product damage caused by battery exposure to extreme heat, store the device out of direct sunlight.

Do not use a sharp object to remove batteries.

CAUTION

Contact your local waste disposal department to properly recycle the batteries.

Device Information