Low Power Mode
The compass page displays the time of day , direction of travel in
À
degrees , and cardinal direction
Á
.
Â
The altimeter page displays the time of day , pressure altitude
À
, and barometric pressure .
ÁÂ
The temperature page displays the time of day , temperature ,
À Á
and density altitude .
Â
Tracking or Navigation Modes
The compass page displays the bearing to the nearest airport ,
À
compass ring , and direction of
Á
travel in degrees (tracking
Â
mode only).
The horizontal situation indicator (HSI) displays the course line pointer , bearing to the next
À
waypoint ,
Á
, and course deviation indicator
Â
(CDI) . The dots indicate the
Ã Ä distance of deviation (navigation
mode only).
The altimeter page displays the alert altitude (Setting the
À
Altitude Alert), pressure altitude , and barometric pressure .
ÁÂ
The temperature page displays the time of day , temperature ,
À Á
and density altitude .
Â
The map displays your current location and direction , the route
À
to your next waypoint , and the
Á
bearing to your next waypoint .
Â
The nearest airport page displays
the airport identifier , bearing to
À
the airport , distance to the
Á
airport , track over ground ,
 à and the estimated time to the
airport .
Ä
Tracking or Navigation Modes
The instruments page displays your ground speed , altitude ,
À Á
track over ground , and the
Â
vertical speed in feet per minute
.
Ã
The next waypoint page displays the waypoint name , bearing to
À
the waypoint , distance to the
Á
waypoint , track over ground ,
 à and the estimated time to the next
waypoint (navigation mode
Ä
only).
Setting the Altitude Alert
You can set an alarm to vibrate when you reach a specified altitude.
NOTE: The altitude alert is not available in low power mode.
1From the time of day page, select 
until the altimeter page appears.
2Select the action key.
3 Select Set Alert.
4 Enter the altitude at which the alert is triggered.
Setting the Barometric Pressure
You can manually enter the current barometric pressure. This can help to improve the accuracy of the pressure altitude reading.
1From the time of day page, select 
until the altimeter page appears.
2Select the action key.
3 Select Set Baro..
4 Enter the current barometric pressure.
Turning on a Sensor Mode
The default sensor mode is on demand mode, which offers you quick access to compass, altimeter, barometer, or temperature data. You can also put the device in always on mode to display continuous sensor data.
NOTE: If you have an optional heart rate monitor or speed and cadence sensor paired with the device, your device can display continuous heart rate or speed and cadence data.
1Select the action key.
2Select Setup > Sensors > Mode > Always On.
Acquiring Satellite Signals and Recording a Track
Before you can use the GPS navigation features, such as recording a track, you must acquire satellite signals.
The time and date are set automatically based on the GPS position.
1Select the action key.
2 Select Start GPS.
3Go to an area with a clear view of the sky and remain stationary while the device acquires satellite signals.
indicates the device acquired satellite signals successfully.
4Walk around or travel to record a track. Your distance and time appear.
5Select 
to view the loop of data pages.
6 Hold 
.
2 | Introduction |