Getting Started
WARNING
See the Important Safety and Product Information guide in the product box for product warnings and other important information.
Setting Up the Pro Trashbreaker System
Before you can use the Pro Trashbreaker system, you must set up the devices.
1Attach the dog collar device to the collar strap (Attaching the Dog Collar Device to the Collar Strap).
2Charge the handheld device (Charging the Handheld Device).
3Charge the dog collar device (Charging the Collar).
4Turn on the devices (Turning On the Dog Collar Device).
5If necessary, pair the dog collar device with the handheld device (Pairing a Dog Collar Device with the Handheld Device).
Device Overviews
Pro Trashbreaker Handheld Device
Intensity level and training mode dial
À
Battery level
Á
Dog collar device toggle switch
Â
Training keys
Ã
Pro Trashbreaker Dog Device
Power key
À
Status LED
Á
Lights
Â
Contact points
Ã
Charging clip contacts
Ä
Attaching the Dog Collar Device to the Collar Strap
1 With the buckle facing outward, insert the end of the collar
À
strap through the slot on the collar device.
Á
2 | Pull most of the collar strap through the two slots  on the |
| dog device. |
3 | Insert the end of the collar strap through the slot à on the |
| opposite side of the device. |
4Pull the strap until it is tight across the front of the device.
5 Wrap the antenna keeper around the collar strap.
Ä
6NOTE: Do not bend the antenna sharply. You should lengthen the collar strap on the side with the antenna keeper to avoid bending the antenna sharply.
Slide the antenna through the antenna keeper.
Å
Charging the Handheld Device
You should fully charge the battery before you use the device for the first time or whenever the battery is low (Checking the Battery Level). It is normal for the battery to discharge in approximately 7 to 10 weeks when the device is not in use. Charging a fully depleted battery takes about 2 hours.
NOTE: The device will not charge when it is outside the temperature range of 32° to 104°F (0° to 40°C).
1 Lift the weather cap .
À
2Plug the small end of the power cable into the
on the device.
Á
3Plug the other end of the power cable into an appropriate power source.
The status LED is solid red when the device is charging.
4After the status LED turns solid green, unplug the power cable from the device.
Getting Started | 1 |