4Grip the rotary switch connector wires close to the connector, and pull the connector perpendicular to the circuit board to disconnect the rotary switch connector from the device.
5Remove the two screws from the battery plate.
6 Lift up the battery plate.
7Remove the old battery from the back plate, noting the orientation of the battery.
The battery fits tightly. It may be necessary to pry the battery out of the back plate using a
8Install the new battery into the back plate with the label side up, using the same orientation as the old battery.
The battery orientation is noted graphically inside the back plate.
9Replace the battery plate to its original position.
10Replace and tighten the battery plate screws.
11With the new battery, connect the battery connector to the device.
When properly installed, the connector plug snaps into the port.
12Reconnect the rotary switch connector to the device.
When properly installed, the connector plug snaps into the port.
13Verify the gasket is not damaged and is completely seated in the groove on the front half of the device.
14While ensuring the battery and rotary switch wires are not pinched, hold the back plate and the device firmly together, and replace all eight security screws without tightening.
15Verify the back plate and the device are aligned with no gaps.
16Tighten the screws evenly.
17Verify the gasket is not sticking out of the device.
Pro Trashbreaker Dog Collar Device Components
Gasket
Å
Front enclosure
Æ
Replacing the Battery Assembly
Before you replace the battery, you must remove all dirt, water, and debris from the device. You also need a small Phillips screwdriver and the security screwdriver included with the battery replacement kit.
You can purchase a replacement battery at http://buy.garmin.com. You should use only an official Garmin replacement part.
1 Remove the three screws from the cover over the VHF
À Á
antenna .
Â
2Pry off the cover.
3Remove the screw securing the VHF antenna to the back plate.
4Remove the six screws from the top plate, and remove the top plate.
5Remove the two screws from the battery plate, and remove the battery plate.
6Grip the battery connector wires close to the connector, and pull the connector perpendicular to the circuit board to disconnect the battery connector from the device.
7Remove the battery.
The battery fits tightly. It may be necessary to pry the battery out of the back plate using a
8Install the new battery into the front enclosure with the label side of the battery facing up, and the lead edge of the battery placed under the contact ledge of the device.
9Replace the battery plate, and replace and tighten the two screws.
Security screws
À
Top plate
Á
Battery plate screws
Â
Battery plate
Ã
Battery
Ä
10Verify the gasket is not damaged and is completely seated in the groove.
11With the new battery, connect the battery connector to the device.
Device Information | 5 |