After the power cable and the GPS antenna (as well as any optional Garmin Marine Network devices, NMEA 0183 devices, NMEA 2000 connections, or video connections) are wired to the boat, connect the cables to the GPSMAP 6000/7000 series chartplotter.
Note: You must install the locking rings before connecting the cables to the chartplotter (page 6).
To connect a cable to the back of a GPSMAP 6000/7000 series chartplotter:1.Carefully press the cable into the correct port on the back of the chartplotter until it is firmly seated. Do not force the cable, because this may damage the pins.
2.After the cable is seated, turn the locking ring clockwise until it is tight. Be careful not to overtighten the locking ring.
| ➊ |
|
| ➍ |
|
|
|
| ➋ | ➎ | |
| ➊ | ➊ |
| ➌ | |
|
|
| ➏ |
|
|
| GPSMAP 6008/6208/6012/6212/7012/7212 Connectors |
| |||
➋ | ➊ |
|
| ➎ | ➍ |
|
|
|
| ||
| ➊ | ➊ |
| ➌ | ➐ |
|
|
|
|
| ➏ |
|
| GPSMAP 7015/7215 Connectors |
| ||
➊Garmin Marine Network connectors (×3) (Black) |
| ➎Video connector (Yellow) |
| ||
➋NMEA 2000 connector (Black) |
|
| ➏Grounding lug (unused in a typical installation) | ||
➌NMEA 0183 connector (Blue) |
|
| ➐Video 2 connector (GPSMAP 7015/7215 only) (Purple) | ||
➍Power connector (Red)
Updating the Chartplotter SoftwareThe GPSMAP 6000/7000 series chartplotter may contain a software update SD card. If so, follow the instructions provided with the card.
If a software update SD card is not included, visit www.garmin.com to make sure your chartplotter software is
GPSMAP 6000/7000 Series Installation Instructions | 17 |