Figure 12
Figure 13
Figure 14 | 8 |
|
|
Step Ten:
Use the removed cylinder head bolt to mount the throttle actuator bracket as shown.
Note: Bend the loom holder out of the way temporarily to gain access to the bolt, and
then bend it back into place to hold the wire
loom & hose in place away from the throttle actuator as shown in Figure 13.
Torque bolt 30Nm/21.5 ft.lbs
Step Eleven:
Remove the nut & lock washer from the throttle arm of the carburetor as seen in
Figures 14 & 15.
Figure 15
