| Message | Action |
| Check Paper Size | The paper size setting is different from the size of the loaded |
|
| paper. Load the correct size of paper in the specified paper |
|
| source. To clear this error, select Clear Warning from Reset. See |
|
| page 73 for instructions. |
|
|
|
| Check Paper Type | The loaded paper type does not match the paper type setting in |
|
| the printer driver. Check that you loaded the correct paper size |
|
| and type in the current paper source. To clear this error, select |
|
| Clear Warning from Reset. See page 73 for instructions. |
|
|
|
| Cover open error | The ADF cover is open. Close the ADF cover, and try scanning |
| (CX11NF only) | again. |
|
|
|
| Cover X Open | The specified cover is not closed completely. Open the cover, |
|
| then close it securely. |
|
|
|
| Document Error | You are trying to copy an original that is not supported by the |
|
| product. Remove the original from the document table. |
|
|
|
| Fax error | You turned on the CX11NF without the fax module installed. Turn |
|
| off the CX11NF, install the fax module, and turn it on again. If the |
|
| error occurs again, contact Epson as described on page 128. |
|
|
|
| Form Feed | The CX11N is ejecting paper after you pressed the x B&W Start |
|
| or x Color Start button, then held down the x B&W Start or |
|
| x Color Start button for more than three seconds. |
|
|
|
| Install C/M/Y/K | The indicated toner cartridges are not installed in the product. |
| TnrCart | Install the Cyan, Magenta, Yellow, or Black cartridges, as |
|
| indicated. See page 82 for instructions. |
|
|
|
| Insufficient memory | Wait for a few minutes until the current copy job is finished. Then |
|
| try copying again. If it still doesn’t work, you need to add more |
|
| memory. |
|
| When you place multiple documents on the ADF and when you |
|
| make continuous |
|
| ADF with the default memory (128MB), the CX11NF may have |
|
| insufficient memory to copy. We recommend adding a memory |
|
| module so that the total memory size is 256MB or higher. |
|
|
|
| Manual Duplex | Printing on one side of the paper is finished in manual duplex |
|
| mode. Reload the printed paper into the MP tray and press the |
|
| x B&W Start or x Color Start button to continue. |
|
|
|
| Mem Overflow | The CX11N has insufficient memory to perform the current task. |
|
| Press the x B&W Start or x Color Start button to resume |
|
| printing, or press the y Cancel button to cancel the print job. |
|
|
|
| Network module | Turn off the CX11N, check if the network module is installed |
| error | correctly, and turn it on again. If the error occurs again, contact |
|
| Epson as described on page 128. |
|
|
|
100 Solving Problems |
| |