Garmin TR1-Gold manual Step Two, Step Three, Step Four

Step Two:

Install the bolt you just removed into the same hole from the starboard side of the motor to the port side. Put a little thread lock on the protruding end of the bolt. Thread the bolt’s end in to the Standoff Nut (item 1) as shown in figure 6 and tighten the it.

Figure 6

Step Three:

Remove the two rear bolts from the lower motor vibration isolation mounting shroud as shown in figure 7.

Figure 7

Step Four:

Again, install the bolts you just removed into the same holes from the starboard side of the motor to the port side. Put a little thread lock on the protruding ends of the bolts. Thread the bolts into non-flat side of the Standoff Nut Plate (item 5) as shown in figure 8 and tighten the them.

Figure 8 Page 5