Magnum P62-Series Hardened Switches | Installation and User Guide (12/02) |
3.0INSTALLATION
This chapter provides instructions for installing Magnum P62-Series units.
3.1Locating Magnum P62F-Series 10/100Mb Ethernet Switches
The location of a Magnum P62-Series Hardened Switch is dependent upon the physical
layout of the network. The rugged 18-gauge sheet steel case that acts as a heat sink will normally protect the P62-Series from accidental damage in any application setting. Install P62F models so that the metal case of the unit is in contact with a metal surface (such as a pedestal in the earth or an equipment enclosure box) which does not exceed the ambient rating of the unit. Install mP62 models mounted vertically, attached to any wood or metal surface or in free air.
Designed primarily for specific applications such as roadside traffic data collection and control stations, unheated and or high temperatures locations, above-the-ceiling mounts in commercial buildings, industrial boiler rooms, mines and quarries, irrigation and pipeline facilities, on-board ships, cell towers, data communication huts and pedestals, aeronautical installations and military sites, the Magnum P62s support DC power input for high reliability and AC power for convenience in out-of-the way locations. Locate the P62-Series unit near any AC power (or any 20-70VDC three-wire (+, GND, -) power source for DC models) that is within the range of the unit. When installing the unit, be sure to maintain an open view of the top surface to visually monitor the status LEDs.
3.1.1Mounting position and materials
The Magnum P62-Series Hardened Switch should be securely mounted in a vertical
position with appropriate screws. Rubber “feet” (if any) that would insulate the case from metal- to-metal contact with the mounting surface should be removed. The full temperature rating of the P62F unit cannot be achieved if it is not properly mounted on metal.
The Magnum P62-Series Hardened switches are quite heavy (3.5 lbs, 1.6 Kg) because of its 18-gauge high-strength steel case enclosure. Because of its weight, it is very important to select a sturdy place and carefully attach it to metal surface. Attaching P62F’s to a metal surface is necessary to allow the thermal heat transfer from the case, achieving rated ambient temperature specifications. The mP62’s can be mounted on any material.
3.1.2Mounting dimensions
Each Magnum P62-Series Hardened Switch is normally mounted with screws in a
vertical (cables at the bottom) position. The base plate of the unit has screw holes cut out, two top and two bottom. The spacing for the mounting screws is a rectangle 3.35” x 7.92” (8.5cm x
www . GarrettCom . com
