Magnum P80F & P80C Personal Switches

Installation and User Guide (07/03)

When the up-link port is used to cascade two P80-series Personal Switches, the auto-sensing feature will cause the connecting link to operate at 100Mbps speed and full-duplex mode.

2.4 Fiber port, ST or SC Connector for Model P80F

Tx Rx UPLINK

= X

F

H

Tx Rx

F H

UPLINK

=

X

F

H

100Mbps Fiber port, ST-type mm

or

SC type (single-mode or multi-mode)

The Fast Ethernet fiber switched port on the Magnum P80F is set to operate at fixed 100Mb speed for guaranteed high performance. The P80F’s fiber port is factory-built as either a multi-mode ST, multi-mode SC, multi-mode MTRJ or single-mode or long-reach SC connector. The 100Mb fiber port will run at 100Mbs speed at all times with manually selected full- and half-duplex capability. The 100Mbps fiber port is a switched port and performs as a domain, providing a high bandwidth backbone connection (no media converter is required!) and supporting long (up to 40km) fiber cable distances for installation versatility.

Ports 2SW (the fiber port) has an “F - H” user-selectable manual switch. When set in the “F” position, it forces full-duplex mode. When set in the “H” position, it forces half-duplex mode, still at 100Mbps speed.

On Magnum P80F units, there are three LED’s for the switched ports. One (LK/ACT) is steady ON to indicate LINK, blinking indicates the port is transmitting and receiving. The SPEED LED is ON for 100Mbps and OFF for 10 Mbps (when LINK is made). The F/H indicates full-duplex when ON, when it is OFF, operation is half-duplex.

A fiber cable must be connected to the 100Mb port and a proper link (LK lit) must be made with the device at the other end of the cable in order for these LEDs to provide valid indications of operating conditions.

www . GarrettCom . com

8

Page 12
Image 12
GarrettCom P80C manual Fiber port, ST or SC Connector for Model P80F, 100Mbps Fiber port, ST-type mm