GarrettCom manual Powering the Magnum P80F and P80C

Magnum P80F & P80C Personal Switches Installation and User Guide (07/03)

(FLP) coding for the 100BASE-TX signaling system. When connecting a NIC to the P80F or P80C, it may be necessary to reload the NIC drivers on the user device if the NIC has been communicating with a protocol other than 100BASE-TX (such as 10BASE-T). When 100Mb operation is agreed and in use, the SPEED LED is illuminated steady ON. It is OFF if there is no traffic or if 10 Mbps traffic.

3.3Powering the Magnum P80F and P80C

Each Magnum P80F and P80C Personal Switch is provided with an external power supply, and has a jack for the DC power cord in the rear. A lightweight DC power cord for

5V, 2.0 amps is supplied with each unit. The small DC power cord from the power supply plugs into the matching rear power jack of the P80F and P80C Personal switchess. When the power is applied, the green PWR LED will illuminate.

Each Magnum P80F and P80C power supply supports standard AC installation environments and comes in two types; one version for AC input power of 115vac at 60Hz for “- d ” models, and other version of 230vac at 50 Hz for “-i ” models that have IEC power cable connector in the external power unit.

Examine the power supply to make sure the version you have is the right type for your AC power system. The 115vac version has a small transformer integral with a convenience power outlet plug, and a lightweight DC power cord to the applicable power jack on the Switch. The 230vac version has a small transformer integral with an IEC-type power plug for a user- supplied AC power cord with a convenience power outlet plug.

www . GarrettCom . com

18